Air Jet Mill Manufacturers in Uganda

In order to obtain a very small particle size for the specialty materials or pharmaceuticals, typical mechanical milling may produce substandard results. An Air Jet Mill relies on a stream of compressed air or gas to accelerate the particles and relies on the momentum of particle-to-particle collisions for the size reduction, in the absence of conventional grinding surfaces.

• Fluid Energy Milling: High-velocity air or gas creates the energy for particle-to-particle collision and size reduction.
• Fine Particle Production: The system is suitable for applications where very small particle sizes are required.
• Low Mechanical Contact: Product reduction primarily occurs through particle collisions rather than direct contact with conventional grinding tools.
• Controlled Classification: The airflow pattern can help separate finer particles from material that requires further size reduction.
• Suitable for Sensitive Materials: The absence of traditional grinding surfaces can be useful for selected materials where contamination or excessive mechanical heat needs consideration.
• Process Flexibility: The equipment can be configured according to feed characteristics, desired particle size, and required throughput.

Material hardness, feed size, particle morphology, density, moisture, gas pressure, target particle size, and production rate all influence the appropriate air jet milling configuration.

Air Jet Mill Suppliers in Uganda

An Air Jet Mill offers a distinct advantage for fine size reduction by employing high-velocity air or gas for the work of the milling process. Particles are accelerated and collide within the milling zone, and therefore, fine powder size can be obtained without the use of conventional mechanical grinding surfaces.

As reliable Air Jet Mill Suppliers in Uganda, we consider the material and micronizing objective before recommending a suitable system. Equipment selection considerations include feed particle size, desired final size, material density, flowability, moisture level, gas requirements, and anticipated throughput.

During operation compressed air or other suitable gas is injected into the milling chamber at high velocities. The air flow grabs the particles and speeds them up in the chamber. The size reduction effect is due to the collisions of particles and the air stream helps to carry finer material to the classification or collection section.